Covered in sweat and grime, Strom ran the file along the last tooth of the final gear. Finally, they were ready to assemble his machine, and all he could do was hope it would work. Nagging fears of failure made his stomach ache. Hard work helped keep his mind from worry, and he poured himself into the task. If his boiling machine did not pour glass, then it would not be due to a lack of effort.
Milo hovered nearby, always silent but always watching. He knew they were nearing completion, and Strom thought he might not be able to stand the anticipation any longer.
"I think it's ready to go on the shaft," Gustad said. "You've done an excellent job. Now it's time to put your idea to the test. Are you ready?"
"I'm ready," Strom replied after he secured the final gear in place. With dread, he grabbed the handle and started to crank. Slowly the crucible began to turn. After cranking the crucible back to the upright position, Strom filled it with sand and placed a bowl beneath it. Trying to be as smooth as he could, he cranked the handle and simulated the pour.
"Just a little too fast," Milo said. "It accelerates the pour too soon."
"I can't believe it works at all," Osbourne said.
Strom ignored Osbourne's comment, determined to find a way to slow the initial part of the pour. "What if we cut off the first part of the strap and stitch on something thinner; then it won't accelerate much until it reaches the thick strap," he said.
Milo produced a sack made of strong but thin material, and he cut a length from it. After a few more tests pouring sand, Milo calculated the length of strap to be replaced. Stitching the light material and leather proved to be difficult, but Gustad showed Strom how to use an awl to make holes in the leather.
After a few more test pours, Milo declared the pouring machine ready for a test with real glass. They were running out of sand, and Strom felt the pressure.
When Osbourne pulled the crucible from the furnace, he performed his practiced movements and placed the rod on Strom's machine. When he went to secure the strap, though, the heat was too much, despite his thick, leather gloves. By the time the strap was attached, the glass had already cooled too much.
"Don't despair, young Strom. No one designs machines without flaws; the real challenge is to overcome those flaws. We'll just find a way to fix it and try again. Eventually we will succeed."